Bonjour la communauté :) voilà mon problème: je souhaite une meilleure utilisation sans faille de mon 8214 PIKO 2rails DCC sound ESU V5, j'ai donc correctement branché le powerpack à mon décodeur ,mais là rien ne se passe, le powerpack produit aucun effet même en augmentant la CV113. J'en appelle à votre savoir pour m'éclairer sur ce problème de connexion entre le décodeur et le powerpack. Bonne journée à tous
Je lis ceci :
Citation10.10. Configure the PowerPack
When you connect an external capacitor or PowerPack, you are able to make the decoder switch off after a certain time. CV113 is responsible for that, since you are able to determine at what time the decoder is to switch off (as a multiple of 0.0328 seconds). You should set a time between 0.3 and 1.0 seconds to prevent your locos from driving too far during an emergency.
For the PowerPack to work, the function output responsible for the charge (typically AUX9 for LokSound, AUX7 for LokSound micro) must be configured to the ,,PowerPackControl" function.
Set CV 31 = 16, CV 32 = 0 first.
Then set CV339 = 31 for LokSound (AUX9)
Then set CV323 = 31 for LokSound micro (AUX7).
Mais peut-être savais-tu déjà ...
Merci beaucoup de votre partage de connaisances 8),je vais tester tout cela
J'ai eu aussi le même problème réglé par un problème de CV.
si le decodeur est origine piko sa ne marche pas.On a chercher longtemps mais pas trouver de solution sauve remplace par un vrai esu sound